Vizualization of measurment points and fitted surface.

Clearly showing the effect of outlier points on the fitted surface, it is necessary to remove the points created when passing through the groove zone.

Next measurments:

  • In subsequent measurements it is necessary to record the angle at which the groove starts and ends in order to remove the outlier points, or to take the measurement only up to the groove, then pick up on the Z axis and then continue measurment in the other direction.
  • In subsequent measurements it is necessary to record the angle at which the groove starts and ends in order to remove the outlier points, or to take the measurement only up to the groove, then pick up on the Z axis and then continue measurment in the other direction.
  • Reset Z-axis 0 point at the begining of measurment.
  • Calculate outer layer measurments to cartesian coordinates